Brocade 150-130 - Brocade Certified Network Engineer 2012
Which two Layer 2 network discovery protocols are used to detect PoE power requirements?
(Choose two.)
OU need to improve redundancy in your LAN as well as increase bandwidth between switches using a Layer 2 protocol.
Which feature will provide this?
Optical monitoring is not returning data. What are three reasons for this happening? (Choose three.)
An identical route has been discovered by OSPF and RIP. By default, the OSPF route is chosen and added to the routing table. What should be done to allow the RIP route to be preferred?
In a DR/BDR election, what will be the result for Router 1 based on the information shown in the exhibit?
An engineer wants to implement Policy Based Routing (PBR). The IP address block to be matched is 100.100.100.128/25. Which ACL would match the traffic affected by PBR?
What is the default administrative distance for RIP?
You are implementing an OSPF network with five defined areas. You want to configure OSPF area route sharing to other specified OSPF areas.
Which router will you need to configure to share area routes with other area routes?
Which two destination addresses are used in an ARP request if the source station's IP address is:
192.168.5.12/16? (Choose two.)
Which two results does the link-aggregate configure key
