Cisco 300-415 - Implementing Cisco SD-WAN Solutions (300-415 ENSDWI)

Which protocol is used between redundant vSmart controllers to establish a permanent communication channel?

Refer to the exhibit. An engineer must configure the Overlay Management Protocol route preference so that when B2 tries to reach host routes advertised by B1 it always chooses the MPLS circuit. Which two match conditions must be configured to accomplish this task? (Choose two.)

Which component of the Cisco SD-WAN network assures that only valid customer nodes are participating in the overlay network?

What is an advantage of using auto mode versus static mode of power allocation when an access point is connected to a PoE switch port?

Refer to exhibit. An engineer is troubleshooting tear of control connection even though a valid CertificateSerialNumber is entered. Which two actions resolve Issue? (Choose two)

Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?

A)

B)

C)

D)

An enterprise is continuously adding new sites to its Cisco SD-WAN network. It must configure any cached routes flushed when OMP peers have lost adjacency Which configuration allows the cached OMP routes to be flushed after every 24 hours from its routing table?

Which data policy configuration influences BGP routing traffic flow from LAN to WAN?

A)

B)

C)

D)

Which OMP route is selected for equal OMP route preference values on WAN Edge routers?

Which configuration defines the groups of interest before creation of the access list or route map?

A)

B)

C)

D.