Black Friday Rush: 75% Off All Exam Bundles! Apply the coupon code below before the offer expires! - Ends in 0d 00h 00m 00s - Coupon code: newyear

HP HPE7-A08 - HPE Aruba Networking Certified Professional - Switching

Page: 4 / 5
Total 162 questions

You have applied the following OSPF configuration but are seeing the output from the command below. What is the reason for this?

A.

A loopback interface hasn ' t been configured on Agg-2

B.

OSPF interfaces are passive by default

C.

A different OSPF process ID is used on each switch

D.

A Layer-3 interface has not been associated with a VRF

You need to configure BGP on an HPE Aruba Networking switch using AS 65010. What is required when establishing peering with neighboring devices using eBGP AS 65100?

A.

Use of peer AS65001

B.

Use of route-reflector

C.

Use of directly connected peer

D.

Use of address-family ipv4 internal

Refer to the partial exhibit from an HPE Aruba Networking CX 8325:

A new port 1/1/44 needs to be configured to connect to a 29301, which has the following configuration:

Which configuration would be used?

A.

B.

C.

D.

You are deploying a pair of VSX switches parallel to some existing HPE Comware switches. You would like to configure a common first-hop redundancy protocol as part of your migration strategy. Which of these would be suitable?

A.

Active Forwarding

B.

HSRP

C.

VRRP

D.

Active Gateway

Your customer’s network experiencing a severe broadcast storm, which you suspect is caused by a loop somewhere at the network edge. You start by disconnecting all the switch downlinks from the aggregation switch, checking CPU utilization, and then reconnecting the downlinks one at a time.

Which troubleshooting methodology does this exemplify?

A.

Top-down/Bottom-up

B.

Replace configuration

C.

Spot the difference

D.

Divide and conquer

Refer to the exhibit for an HPE Aruba Networking CX 6300M VSF:

If Member ID 1 fails, what would be the state of Member ID 2?

A.

Conductor

B.

Standby

C.

Not present

D.

Member

Match the terminology related to 802.1x authentication.

Your customer ' s CX switches are managed in HPE Aruba Networking Central. If a VSX primary switch is accidentally powered off, which alert will be triggered?

A.

Switch Reboot

B.

Switch Stack Conductor Change

C.

Switch Disconnected

D.

Switch STP Root Change

Refer to the exhibit:

A senior network architect has created the configuration above. You are implementing the setup in Building A and C. The actual fiber distance between the building locations is 200m / 656ft utilizing OM4 cabling.

What needs to be changed in the configuration based on the actual environmental conditions to complete the installation and 7 other CX 6300 VSF stack connections in the future?

A.

Replace the 25GR optics with 10SR

B.

Replace the 25GR optics with 25LR

C.

Replace the 25GR optics with 10LR

D.

Replace the 25GR optics with 25SR

You need to run a packet capture on a CX switch and be able to view the full output on a remote device in real-time. What is the best way to do this?

A.

Configure a mirror session using ERSPAN to a computer running Wireshark

B.

Inspect the summary of the packets in real time on the switch using tcpdump

C.

Configure a mirror session with another port on the switch as the destination

D.

Configure a mirror session to the CPU, use tshark to capture it to a PCAP file