Juniper JN0-452 - Mist AI Wireless - Specialist (JNCIS-MistAI-Wireless)

In Juniper Networks Mist AI Wireless, Service Level Expectations (SLEs) are used to measure and assure real user experience across the wireless network. Each SLE is built on specific classifiers, which break down failures into root causes such as DHCP, DNS, authentication, RF conditions, or application issues. Understanding which SLEs rely on DHCP classification is essential for accurate troubleshooting.

The two Wireless Assurance SLEs that include a DHCP classifier are Successful Connects and Time to Connect.

The Successful Connects SLE measures whether client devices are able to complete the full connection process successfully. This process includes association, authentication, and critically, DHCP address assignment. If a client fails to obtain an IP address, the connection is considered unsuccessful, and the failure is explicitly classified as a DHCP issue within this SLE.

The Time to Connect SLE measures how long it takes for a client to connect from the moment it initiates association until it is fully usable on the network. One of the key components of this timeline is the DHCP transaction time. Slow DHCP responses, retransmissions, or server delays directly increase the overall connection time, and Mist classifies these delays under DHCP within the Time to Connect SLE.

The other options are incorrect for the following reasons:

Roaming SLE focuses on re-association, authentication, and mobility events, not DHCP, since IP addressing is typically retained during roaming.

Coverage SLE evaluates RF signal strength, SNR, and cell overlap, with no dependency on DHCP.

Throughput SLE measures data transfer performance after connectivity is established and does not analyze DHCP behavior.

Therefore, the correct answer is Successful Connects and Time to Connect, as both SLEs directly depend on and classify DHCP-related performance and failures within Mist Wireless Assurance.

The WLANs with SSIDs NETGEAR24 and Bob24WiFi will cause adjacent channel interference because they are using overlapping channels in the 2.4 GHz frequency band.

According to the Lecture 3 - Radio Frequency and Antenna Fundamentals - Part 2 document3, two layers that are different between Ethernet and Wi-Fi in the OSI networking model are:

Media access control (MAC) sub-layer, which is part of the data link layer and defines how devices access and share the wireless medium.

Physical layer, which defines how data is encoded and transmitted over the wireless medium.

When deploying multiple Mist APs across many sites in your network and grouping similar devices together to easily apply consistent WxLAN policies across multiple sites, you should use device profiles.

Basic data rates are the required data rates that all devices on a wireless network must support in order to connect to the network. These rates are used for management and control frames and can affect the performance of the network.

According to the Lecture 3 - Radio Frequency and Antenna Fundamentals - Part 2 document2, basic data rates are required data rates that all devices must support to communicate on a WLAN.

The Wi-Fi Assurance SLE and classifier that would provide information about possible interference from a neighboring Wi-Fi network are Capacity and Wi-Fi Interference.

According to the Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide2, a non-compliant AP is an AP that has a different hardware model than what is expected by the cloud configuration. This can happen when an AP is replaced with an incorrect model or when an AP is moved to a different site group that has a different hardware model requirement. The solution is to replace the AP with the correct hardware model.

Referring to the exhibit and considering that it is in the USA, the WLAN with SSID Eero1234 is not configured to industry best practices while the WLAN with SSID NETGEAR24 is configured to industry best practices.