Netapp NS0-163 - NetApp Certified Data Administrator ONTAP Professional

Before enabling an active/active configuration, you should verify and compare the configuration of the nodes. Which tool can perform this task?

Refer to the exhibit.

A company has three servers that are using the iSCSI protocol to connect to a two node NetApp ONTAP cluster. The server administrator notices that half of the paths are down. The administrator checks the ONTAP cluster and notices the servers are logging into only the first controller.

Which two steps should the administrator take to troubleshoot the issue? (Choose two.)

An administrator has an ESXi cluster with VMware VMFS LUNs on an AFF system. Alter troubleshooting performance issues, the administrator determines that timeout best practices are not set on the hosts.

Which NetApp tool would apply the best practice settings?

An aggregate is composed of twelve 36-Gigabyte disks. A drive fails and only 72-Gigabyte spare disks are available Data ONTAP will then perform what action?

Fill in the blanks for the following statement:

The qtree specified for_____must not exist on the secondary system before you run the_____command.

Which two conditions would prevent an ONTAP upgrade? (Choose two.)

Which SyncMirror command mirrors an existing unmirrored aggregate where Data ONTAP selects the disk drives?

To remove a cluster setup, you must perform the following steps.

1. Type cf disable.

2. Unlicense cluster.

3. Remove partner entries for network interfaces from the /etc/rc file.

4. Halt and make sine the partner-sysid is blank.

5. Power down and remove the cluster interconnect card.

6. Perform steps 1-5 above on the partner node.

Which tool should an administrator use to identify the number of empty SAS ports on an existing cluster?

What would allow for an automatic switchover of an SM-BC relationship in case of a site disaster7