Summer Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: ecus65

Cisco 200-301 - Cisco Certified Network Associate

Cisco 200-301 Premium Access     Download Demo    
Page: 9 / 13
Total 1069 questions

Which network plane is centralized and manages routing decisions?

A.

policy plane

B.

management plane

C.

control plane

D.

data plane

When a WPA2-PSK WLAN is configured in the wireless LAN Controller, what is the minimum number of characters that in ASCll format?

A.

6

B.

8

C.

12

D.

18

Which technology can prevent client devices from arbitrarily connecting to the network without state remediation?

A.

802.1x

B.

IP Source Guard

C.

MAC Authentication Bypass

D.

802.11n

Refer to the exhibit.

For security reasons, automatic neighbor discovery must be disabled on the R5 Gi0/1 interface. These tasks must be completed:

• Disable all neighbor discovery methods on R5 interface GiO/1.

• Permit neighbor discovery on R5 interface GiO/2.

• Verify there are no dynamically learned neighbors on R5 interface Gi0/1.

• Display the IP address of R6*s interface Gi0/2.

Which configuration must be used?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the exhibit.

Which prefix does Router 1 use for traffic to Host A?

A.

10.10.10.0/28

B.

10.10.13.0/25

C.

10.10.13.144/28

D.

10.10.13.208/29

An engineer requires a scratch interface to actively attempt to establish a trunk link with a neighbor switch. What command must be configured?

A.

switchport mode trunk

B.

switchport mode dynamic desirable

C.

switchport mode dynamic auto

D.

switchport nonegotiate

Which statement correctly compares traditional networks and controller-based networks?

A.

Only traditional networks offer a centralized control plane

B.

Only traditional networks natively support centralized management

C.

Traditional and controller-based networks abstract policies from device configurations

D.

Only controller-based networks decouple the control plane and the data plane

Refer to the exhibit.

Router R2 is configured with multiple routes to reach network 10 1.1 0/24 from router R1. What protocol is chosen by router R2 to reach the destination network 10.1 1 0/24?

A.

eBGP

B.

static

C.

OSPF

D.

EIGRP

Refer to the exhibit.

With which metric was the route to host 172.16.0.202 learned?

A.

0

B.

110

C.

38443

D.

3184439

Refer to the exhibit.

The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another?

(Choose two.)

A.

Configure the ipv6 route 2012::/126 2023::1 command on the Washington router.

B.

Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.

C.

Configure the Ipv6 route 2012::/126 s0/0/0 command on the Atlanta router.

D.

Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router.

E.

Configure the ipv6 route 2012::/126 2023::2 command on the Washington router.

How does CAPWAP communicate between an access point in local mode and a WLC?

A.

The access point must directly connect to the WLC using a copper cable

B.

The access point must not be connected to the wired network, as it would create a loop

C.

The access point must be connected to the same switch as the WLC

D.

The access point has the ability to link to any switch in the network, assuming connectivity to the WLC

Refer to the exhibit.

Which two prefixes are included in this routing table entry? (Choose two.)

A.

192.168.1.17

B.

192.168.1.61

C.

192.168.1.64

D.

192.168.1.127

E.

192.168.1.254

Refer to the exhibit.

Which route type is configured to reach the internet?

A.

host route

B.

default route

C.

floating static route

D.

network route

What is a characteristic of private IPv4 addressing?

A.

traverse the Internet when an outbound ACL is applied

B.

issued by IANA in conjunction with an autonomous system number

C.

composed of up to 65.536 available addresses

D.

used without tracking or registration

Refer to the exhibit.

The entire contents of the MAC address table are shown. Sales-4 sends a data frame to Sales-1.

What does the switch do as it receives the frame from Sales-4?

A.

Perform a lookup in the MAC address table and discard the frame due to a missing entry.

B.

Insert the source MAC address and port into the forwarding table and forward the frame to Sales-1.

C.

Map the Layer 2 MAC address to the Layer 3 IP address and forward the frame.

D.

Flood the frame out of all ports except on the port where Sales-1 is connected.

Which networking function occurs on the data plane?

A.

forwarding remote client/server traffic

B.

facilitates spanning-tree elections

C.

processing inbound SSH management traffic

D.

sending and receiving OSPF Hello packets

The SW1 interface g0/1 is in the down/down state. Which two configurations are valid reasons for the interface conditions?(choose two)

A.

There is a duplex mismatch

B.

There is a speed mismatch

C.

There is a protocol mismatch

D.

The interface is shut down

E.

The interface is error-disabled

Which action is taken by a switch port enabled for PoE power classification override?

A.

When a powered device begins drawing power from a PoE switch port a syslog message is generated

B.

As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused

C.

If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects

D.

Should a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

What is a difference between RADIUS and TACACS+?

A.

RADIUS is most appropriate for dial authentication, but TACACS+ can be used for multiple types of authentication

B.

TACACS+ encrypts only password information and RADIUS encrypts the entire payload

C.

TACACS+ separates authentication and authorization, and RADIUS merges them

D.

RADIUS logs all commands that are entered by the administrator, but TACACS+ logs only start, stop, and interim commands

A network administrator must to configure SSH for remote access to router R1 The requirement is to use a public and private key pair to encrypt management traffic to and from the connecting client.

Which configuration, when applied, meets the requirements?

A.

Option A

B.

Option B

C.

Option C

D.

Option D