Cisco 300-425 - Designing Cisco Enterprise Wireless Networks (ENWLSD)

An engineer must perform a pre-deployment site survey for a new building in a high-security area. The design must provide a primary signal RSSI of -65 dBm for the clients. Which two requirements complete This design? (Choose two)

A consulting engineer on a brownfield deployment must improve the roaming experience of legacy wireless handheld scanners on a wireless network with a Cisco Catalyst 9800-80 WLC and Cisco 91301 APs The requirement is that when the handheld scanner drops below -75 dBm in RSSI, the WLC should disassociate the scanner so that the scanner looks for a better connection to roam. Which feature must the engineer enable on the controller?

An engineer must produce a passive survey report. The coverage heat map shows the entire site with all signal levels. To see only the desired coverage, which action must the engineer take?

What is the recommended overlap percentage for 2.4 GHz coverage cells in a WLAN design?

A high-density wireless network is designed. Which Cisco WLC configuration setting must be incorporated in the design to encourage clients to use the 5 GHz spectrum?

Which antenna type is most appropriate for covering a long hallway?

An enterprise is using the wireless network as the main network connection for corporate users and guests. To wireless network availability. Two Standalone controllers are installed in the head office. APs are connected to the controllers using a round-robin approach to load balance the traffic. After a power cut, the wireless clients disconnect while roaming. An engineer tried eping from the controller but faits. Which protocol needs to be allowed between the networks that the controllers are installed?

Campus users report a poor wireless experience. An engineer investigating the issue notices that in high-density areas, the wireless clients fail to switch the AP to which are automatically connected. This sticky client behavior is causing roaming issues. Which feature must the engineer configure?

An engineer must ensure that the wireless network can accomplish fast secure roaming by way of caching keys on the access points. Which key caching mechanism is enabled by default on a Cisco AireOS WLC?

A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration

is the cause of this issue?