F5 301a - BIG-IP LTM Specialist: Architect Set-Up & Deploy
Refer to the exhibit.
The http monitor is applied to a pool All members are enabled One pool member stops responding TCP port 80. The server still responds to ping.
What is the resulting status of this pool member?
A virtual server is configured to handle https traffic. The clientssl profile is configured to use a2048-bit RSA key. Due to security requirements, is the LTM Specialist needs to use a 4096-bit RSA key in the future.
What two effects will this change have on the BIG-IP device? (Choose two)
An LI M device is experiencing a high volume of traffic. The virtual server is struggling under the load. The problem appears to be on the server side connections. The virtual server is accepting connections . The virtual server is accepting connections on https and is configured with an SSL profile and http pool.
What should be added to increase the performance of the device?
An LTM device is configure with the wildcard virtual servers displayed below.
A client connection is made to 172.24.31.14:443.
Refer to the exhibit.
The LTM devices LTM3 and LTM2 have four Traffic Groups defined with approximately the sar of failover objects defined in each group.
- Traffic Groups A and C have Default Device set to LTM1
- Traffic Groups Band D have Default Device set to LTM2.
- Traffic Groups B and C do NOT have Auto Failback enabled. Traffic Groups A and D have Auto Failback enabled with a timeout value of 60 seconds.
- Traffic Groups A and D have Auto Fallback enabled with a timeout value of 60 seconds.
Both LTM devices are healthy and able to pass traffic for any Traffic Group.
LTM1 loses connectivity on interface 1.4. The LTM Specialists notified 60 seconds after the interface goes down.
What is the state of the Traffic Groups on each LTM device?
An LTM Specialist needs to enable TCP connection re-use for a non-HTTP application. The application uses a simple request response protocol where each request and response is contained within a single packet.
Which configuration option should the LTM Specialist adjust?
The network team has recently added a new syslog server with IP address 10.1.1.1.
Which command adds the new syslog entry on the F5 LTM device?
A)
B)
C)
D)
A Web Server Administrator uses a manual process to display a page when the service is down.
Which feature on the LTM device should be used to automate the service down page? :
An LTM Specialist observes decreased performance and intermittent connection reap LTM system.
Based on the configuration, which action will address these issues?
Exhibit.
Webserver_pool consists of 6 members. phpAuction_80_pool consists of 2 members LTM1 is the current Active member.
LTM1 loses connectivity to 3 of the 6 members in the webserver_pool LTM2 still has connectivity to all
servers.
What is the expected failover behavior?
