Pre-Summer Sale Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: xmas50

Cisco 350-601 - Implementing Cisco Data Center Core Technologies (350-601 DCCOR)

Page: 7 / 12
Total 382 questions

An engineer must assign a device alias of Marketing to a Fibre Channel port that has a world wide name of 21:00:00:00:11:11:22:22 on a Cisco MDS 9000 Series Switch. Which two commands accomplish this goal? (Choose two.)

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the exhibit. An engineer must create a scheduler task on a Cisco Nexus 9000 Series Switch at 06:00 AM. The task must save the running configuration to a file in the bootflash, then transfer the file from the bootflash to a TFTP server Which command must the scheduler task run after the running configuration is copied to the bootflash?

A.

scheduler job name backup-cfg

B.

copy bootflash:/$(TIMESTAMP)-cfg.$(SWITCHNAME) tftp://192.168.2.1/

C.

scheduler schedule name daylydbackup

D.

cli var name timestamp $(TIMESTAMP)

A network architect considers a Cisco HyperFlex design

solution for a company. The proposed solution is for a virtual environment that is not performance-sensitive, but the solution must have high storage capacity and a low cost. Which Cisco HyperFlex storage configuration should be used?

A.

All-Flash

B.

Hybrid

C.

All-SAN

D.

All-NVMe

Refer to the exhibit. An engineer must configure NX-I to accept only packets that exist in the routing table with the 9.9.9.2/32 source IP address and that are reachable via interface Eth 1/1. Which attribute

to the ip verify unicast source command is needed to meet these requirements?

A.

interlace Elh1/2 with rx keyword

B.

interface Eth1/2 with allow-default keyword

C.

interface Eth1/1 with allow-default keyword

D.

interface Eth1/1 with rx keyword

What is a feature of NFS?

A.

role-based access control

B.

Kerberos-based security model

C.

block-based file access

D.

zone-based

Refer to the exhibit.

The server is sending traffic to the storage server using Fiber Channel protocol. The requirement is for the N5K-1 to forward traffic to MDS9k-1. Drag and drop the configuration steps from the right to complete the configuration for N5K-1 on the left. Not all configuration steps are used.

A company with a small network team purchases 10 Cisco Nexus 9000 Series Switches for a network refresh. Some elements of the existing network infrastructure will be retained, including DHCP and DNS servers. The company wants the network team to use PowerOn Auto Provisioning (POAP) to configure the switches, but the team only has experience with manual configuration. Which two additional network infrastructure components must be configured to use POAP? (Choose two.)

A.

GIT server

B.

SNMP trap receiver

C.

NETBOOT host discovery

D.

SCP file repository

E.

TFTP script server

An engineer must configure a Cisco MDS 9000 Series Switch to store generated log messages to a file. The tile must store logs of the severity of ' warning " and above, and the file size must not exceed 20.000 bytes. Which command accomplishes this task?

A.

logging logfile Local 4 size 20000

B.

logging logfile Logs 3 size 160000

C.

logging logfile messages 2 size 2500

D.

logging logfile LogFile S size 2000

A customer deploys a media server to distribute streaming videos to network clients. The requirement is to allow the video feed to reach only requesting clients. The shared trees must not

propagate the video feed if no clients from that tree request it. To reduce configuration touchpoints, the solution must support the automatic discovery and announcement of RP-set

information. Each router in the network is responsible for selecting the RP. Which configuration set meets these requirements?

A.

router(config-if)# ip pim sparse-sense mode router(config}# ip pim auto-rp router(config)# ip pim send-rp-announce

B.

router(config-if}# ip pim dense-mode router(config)# ip pim rp-address 1.1.1.1 router(config}# ip pim rp listener

C.

router(config-if}# ip pim bidir-enable router(config}# ip pim ssm default router(config}# ip igmp version 3

D.

router(config-if}# ip pim sparse mode router(config)# ip pim bsr-candidate Lo0 router(config)}# ip pim rp-candidate Lo0

An engineer must configure a Fibre Channel port channel on a Cisco Nexus 9000 Series Switch. The configuration must meet these requirements:

    A port-channel protocol negotiation is performed with the peer ports.

    The trunk mode must be explicitly configured for the interfaces.

    VSANs from 10 to 20 must be allowed.

Which command set configures the devices to meet the requirements?

A.

Option A

B.

Option B

C.

Option C

D.

Option D