Winter Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: ecus65

Cisco 350-601 - Implementing Cisco Data Center Core Technologies (350-601 DCCOR)

Page: 1 / 11
Total 347 questions

Which service profile is affected if the default host firmware policy in Cisco UCS Manager is changed?

A.

any service profile that has no host firmware policy defined

B.

any service profile that uses a user-created host firmware policy

C.

any service profile that is not in the root sub-org

D.

any service profile that uses the global-default host firmware policy

Refer to the exhibit. A source is sending a multicast traffic stream to the receiver. How is the multicast traffic expected to flow through the network when it reaches a vPC peer?

A.

The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link. The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.

B.

The multicast traffic is replicated to the ports that joined a given multicast group and the peer link. The multicast traffic stream flows from Agg-1 to Agg-2 over the M1-to-M2 peer link and forwards the traffic over Layer 4 to Access-2.

C.

The multicast traffic is not replicated to the ports that joined a multicast group (224.0.0.13) or the peer link. The multicast traffic stream flows over the vPC link to ensure that orphan ports get the multicast stream in failure scenarios.

D.

The multicast traffic is replicated to the ports that joined a given multicast group and the peer link. The multicast traffic stream flows over the peer link to ensure that orphan ports receive the multicast stream in failure scenarios.

Refer to the exhibit. The network management system that is located at 192.168.10.10 and port 2000 must receive traps from the Cisco UCS Manager called UCSM. The community name is Cisco123! and the SNMP version must be the most secure.

These two commands have already been configured on Cisco UCSM.

UCS-A# scope monitoring

UCS-A/monitoring # enable snmp

Which command set completes the SNMP configu

A.

Option A

B.

Option B

C.

Option C

D.

Option D

An engineer must configure a Cisco MDS 9000 Series Switch for traffic analysis from the storage array. The storage array is connected to the interface fc2/1 in VSAN 10 and the traffic analyzer to fc4/2. The capture file must include ingress and egress traffic between the switch and the storage array. Also, only traffic in VSAN 10 must be captured. Which configuration set meets these requirements?

A.

interface fc4/2switchport mode SD no shutdown!span session 1 source interface fc2/1 destination interface fc4/2 source filter vsan 10

B.

Interface fc4/2switchport mode trunk switchport trunk allow vsan 10 no shutdown!span session 1 source interface fc2/1 tx destination Interface fc4'2 rx no suspend

C.

Interface fc4/2switchport mode auto no shutdown!span session 1 source interface fc2/1 rx destination interface fc4/2 source filter vsan 10 no suspend

D.

interface fc4/2 switchport mode STno shutdown!span session 1 source interface fc2/1 destination interface fc4/2 source filter vsan 10

Refer to the exhibit. A Cisco data center environment is implemented with vPC. The web server replies using the SVI MAC address as the Layer 2 header instead of the HSRP MAC address on VLAN 23. This behavior causes packet drops on the Cisco Nexus 9000 Series Switches due to the vPC loop prevention mechanism The requirement is for the vPC feature to allow N9K_1 and N9K_2 to forward traffic between the NAS server and the web server, even if the HSRP's MAC address is not used on Layer 2 headers for VLAN 23. Which feature must be used to accomplish this goal?

A.

Peer Gateway

B.

ARP Sync

C.

L3 Peer Router

D.

Object Tracking

A DevOps engineer must design a solution for a Cisco Unified Fabric solution to provision, monitor, and troubleshoot the network infrastructure for a data center based on Cisco Nexus

Series Switches. The solution must provide visibility and control of the unified data center. Which solution meets these requirements?

A.

Cisco CloudCenter Suite

B.

Cisco DNA Center

C.

Cisco AppDynamics

D.

Nexus Dashboard Fabric Controller

An engineer is deploying a VXLAN EVPN environment for a customer. The customers environment suffers from a large amount of flooding related to hosts attempting to resolve the MAC to IP mapping on the network segment. Which feature prevents this issue from happening in the future?

A.

anycast rendezvous point

B.

anycast gateway

C.

IPARPSYNC

D.

IP ARP suppression

A network engineer deploys a cloud service for a customer The customer wants complete control over the underlying operating system data and application Which cloud service model must be used to accomplish this goal?

A.

Infrastructure in a service

B.

storage as a service

C.

platform as a service

D.

software as a service

An engineer must implement a Python script to manage Cisco Application Centric Infrastructure (ACI) and endpoint groups. Which Python libraries must be used to parse responses and send requests to Cisco ACI?

A.

socket and JSON

B.

ElementTree and SSL

C.

JSON and ElementTree

D.

JSON and requests

An engineer modifies the virtual port channel domain on a Cisco Nexus 9000 Series Switch using Session Manager Which two commands must the engineer use to confirm the configuration is valid and apply the configuration to the switch? (Choose two.)

A.

Write memory

B.

save bootflash:

C.

verify

D.

checkpoint

E.

commit