Summer Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: ecus65

Cisco 350-801 - Implementing Cisco Collaboration Core Technologies (350-801 CLCOR)

Cisco 350-801 Premium Access     Download Demo    
Page: 2 / 11
Total 361 questions

An administrator needs to create a partial PRI consisting of the first seven timeslots available. Which configuration snippet configures the ISDN E1 PRI for this task?

A.

B.

C.

D.

An engineer must configure switch port 5/1 to send CDP packets to configure an attached Cisco IP phone to trust tagged traffic on it’s access port. Which command is required to complete the configuration?

A.

platform qos trust extend cos 3

B.

platform qos trust extend

C.

platform qos extend trust

D.

platform qos trust extend cos 5

After an engineer implements the FAC and CMC features together, users report that calls take almost one minute to complete and that they occasionally hear the reorder tone. Which two actions address this issue?( Choose two)

A.

Adjust the T302 timer from the default of 15 seconds to 5 seconds to shorten the interdigit timer

B.

Change the code if the problem persists

C.

Advise the user to hang up and try again

D.

Do not wait for the tones immediately dial the FAC and CMC

E.

Advise the user to press the"#"button after dialing the FAC and CMC codes

What is the traffic classification for voice and video conferencing?

A.

Voice is classified as CoS 4, and video conferencing is CoS 5.

B.

Voice and video conferencing are both classified is CoS 3.

C.

Voice is classified as CoS 5, and video conferencing is CoS 4.

D.

Video conferencing is classified as CoS 1, and voice is CoS 2.

An engineer configures a Cisco Unified Border Element and must ensure that the codecs negotiated meet the ITSP requirements. The ITSP supports G.7llulaw and G.729 for audio and H.264 for video. The preferred voice codec is G.711. Which configuration meets this requirement?

A.

B.

C.

D.

Which Cisco lM and Presence service handles failover and state changes in the cluster?

A.

XCP Sync Agent

B.

Cisco Server Recovery Manager

C.

Cisco XCP Connection Manager

D.

XCP router

An engineer is notified that the Cisco TelePresence MX800 that is registered in Cisco Unified communications Manager shows an empty panel, and the Touch 10 shows a corresponding icon with no action when pressed. Where does the engineer go to remove the inactive custom panel?

A.

The phone configuration page in CUCM Administration

B.

The SIP Trunk security profile page in CUCM Administration

C.

The software Upgrades page in CUCM OS Administration

D.

The In-Room control Editor on the webpage of the MX800

How does Cisco UCM perform a digit analysis on-hook versus off-hook for an outbound call from a Cisco IP phone that is registered to Cisco UCM?

A.

On-hook. by pressing the digits and entering "#" to process the call. UCM performs a digit-by-digit analysis; off-hook. UCM analyzes all digits as a string.

B.

On-hook. no digit analysis is performed; off-hook. UCM requires the '#" to start the digit analysis

C.

On-hook. UCM performs a digit-by-digit analysis; off-hook. UCM considers all digits were dialed and does not wait for additional digits.

D.

On-hook. UCM considers all digits were dialed and does not wait for additional digits; off-hook. UCM performs a digit-by-digit analysis.

Refer to the exhibit. An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is used?

A.

G711alaw

B.

No codec is used (missing codec command)

C.

G.711ulaw

D.

G729r8

The IP phones al a customer site do not pick an IP address from the DHCP An engineer must temporarily disable LLDP on all ports of the switch to leave only CDP. Which two commands accomplish this task? (Choose two.)

A.

Switch# copy running-config startup-config

B.

Switch(config)# no lldp run

C.

Switch# configure terminal

D.

Switch(conlicj)# interface GigabitEthernet1/0/1

E.

Switch(config># no lldp transmit