Weekend Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: xmas50

VMware 5V0-42.21 - VMware SD-WAN Design and Deploy Skills

VMware 5V0-42.21 Premium Access     Download Demo    
Page: 2 / 2
Total 52 questions

Company A has recently acquired Company B and needs to establish network connectivity. Company A has only Cisco for firewalls and VPN. Company B is using VMware SD-WAN.

Which VMware SD-WAN Cloud VPN solution should an administrator configure to establish connectivity?

A.

Branch to Non VMware SD-WAN Site.

B.

Branch to SD-WAN Hub

C.

Branch to Main Office VPN

D.

Branch to Branch VPN

A VMware SD-WAN customer has a requirement to enable single sign-on (SSO) authentication to their existing provider (idp) for access to their Orchestrator account.

Which authentication protocol is supported?

A.

OpenID Connect (OlDC)

B.

LDAP

C.

SAML 2.0

D.

TACACS+

Due to very strict security policies an enterprise customer is looking for an on-premises deployment of the VMware SD-WAN Orchestrator and Controllers. Customer data is not expected to flow through this Controller, however it is desirable that management plane traffic towards the Orchestrator coming from VMware SD-WAN Edges can take the overlay tunnels through this controls.

What are some of the needed steps to achieve the requirements above?

A.

Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and enable management plane forward

B.

Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and add static host routes with NAT hand off settings porting to the Orchestrator IPs under Partner Gateway advanced hand off settings

C.

Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plane and Partner Gateway role and add static host mules with NAT hand off settings pointing to the Orchestrator IPs under Partner Gateway advanced hand off settings

D.

Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plant- and Partner Gateway role and add a static default route with NAT hand off settings under Partner Gateway advanced hand oft settings

An Enterprise customer just acquired a new company, and the Network Enterprise administrator was tasked to integrate over 20 new branches into their existing SD-WAN network. However, these branches have overlapping IPs with the existing branches subnets.

A.

Configure a NAT hand off rule at the VMware SD WAN gateway assigned to these new blanches, translating the new branch subnets into a new nan-overlapping subnet

B.

Configure a LAN-side NAT rule at the branch device settings, translating its subnets into a new non-overlapping subnet

C.

Configure a NAT firewall rule in each branch, translating its subnets into a new non-overlapping subnet

D.

Configure a policy based NAT tor each branch translating its subnets Into a new non-overlapping subnet

Given a VMware SD WAN Branch Edge with Dual Internet links A and B:

• Link A has 50 Mb capacity and latency 10ms

• Link H has 50 Mb capacity and latency 10ms

A database backup of 40Mbps is parted, and the traffic classified as low priority bulk traffic.

Which statement is correct?

A.

DMPO will perform pen How load balancing.

B.

Packet duplication will take plant? to ensure both links are optimized.

C.

Packets will be sent nut the highest latency link first as this is low priority bulk traffic

D.

Link Aggregation may take place, and both links could be used.