Huawei H35-211_V2.5 - HCIP-Access V2.5

A single-layer VLAN is limited by the IEEE 802.1Q VLAN ID space (1–4094), i.e., about 4K VLANs. In large PON deployments, when you must separate multiple services (e.g., HSI, VoIP, IPTV) and the user scale approaches or exceeds the 4K ceiling, a dual-layer VLAN (QinQ) design is required to extend the VLAN namespace and implement hierarchical isolation (access VLAN + service/aggregation VLAN).

In IP address discovery mode, eSight does not require L2 same-subnet adjacency; it only requires IP reachability/routing, proper SNMP credentials/alignment, and the operator’s Resource Access permission to poll and add devices. The “same network segment” prerequisite applies to ARP broadcast discovery mode, not to IP address discovery.

In H.248, the MGC controls the MG by creating a Context (also called an empty connection) and then adding terminations to build point-to-point, multipoint, or conference topologies. During call setup the MGC typically creates an empty context first, then binds terminations as media is negotiated.

A is incorrect: contexts and terminations can be modified during the session.

B is incorrect as written (the association/context is released, not “used”).

C is incorrect: an MG limited to point-to-point cannot host three or more endpoints in one context.

Huawei anti-DoS on access boards performs periodic detection. Ports with consecutive detections of abnormal traffic are placed into a blacklist/quarantine state. The system then applies a random back-off interval before re-detecting; if no further anomalies are found, the port can be automatically removed from the blacklist.

In Huawei’s QoS theory (aligned with IETF), the recognized service models are Best Effort, Integrated Services (IntServ), and Differentiated Services (DiffServ). FIFO is a queueing discipline (scheduling method) rather than a service model. FIFO simply forwards packets in arrival order without classification or guarantees, and while it can be used within Best Effort, it is not itself a service model.

The OLT’s anti–IP-attack (control-plane protection) function identifies and rate-limits abnormal or attack traffic to protect the CPU. It does not block legitimate management protocols such as Telnet/SSH by design. Remote management remains available when sourced from permitted hosts and within configured thresholds; administrators can also use trusted-host/ACL policies if needed.

Huawei OLTs support ONT replacement without deleting the original service profile by using ONT replace/auto-find mechanisms. The OLT can bind the new ONT (new SN) to the existing ONT configuration template (service-port, VLAN, QoS, multicast profile, etc.), achieving a smooth replacement without manually removing and re-creating the ONT and services. The statement that you must remove the ONT and re-register from scratch is therefore wrong.

IPv4 multicast (historically “Class D”) occupies the address block 224.0.0.0 through 239.255.255.255. Any upper bound of 238.255.255.255 is incorrect because it excludes the full 239/8 administratively scoped range. This is standardized in the IANA IPv4 Multicast Address Space registry and reflected in foundational multicast specifications.

The statement is wrong. SIP explicitly allows several header fields to appear multiple times within a request or response—for example, Via (one per hop), Route, Record-Route, and Contact may legitimately occur more than once. This is fundamental to SIP routing behavior, where each proxy appends a new Via entry. RFC 3261 explains processing based on the top Via among potentially multiple Via headers, which directly contradicts the claim that “a single information value never appears multiple times