Weekend Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: xmas50

HP HPE0-V15 - Delta - Building HPE Hybrid IT Solutions

Page: 1 / 3
Total 80 questions

Which HPE Proliant server should you recommend for a home office environment where the server will be located in the same office as the user?

A.

HPE ML110

B.

HPE DL20

C.

HPE MicroServer

D.

HPEXL170r

Read the question, and then refer to the exhibit.

display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0

An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.

The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.

What must you do to resolve this issue?

A.

Configure the interface as an access port.

B.

Configure the PVID of the interface to be VLAN 20.

C.

Permit VLAN 20 on the interface.

D.

Configure the interface as an IRF port.

Which storage array feature records only changes made to the base volume and keeps an earlier state of the original volume?

A.

snapshot

B.

clone

C.

virtual volume

D.

volume mirror

You configured a port on an HPE FiexFabric 5900 series switch that is connected to a VMware ESXi server to support multiple VLANs

interface Ten-GigabitEthernet 1/0/11 description server ESXiOl-ethl port link-type trunk port trunk permit vlan 50 port trunk permit vlan 2 port trunk pvid vlan 50

Given the configuration above, what should happen to any untagged traffic coming from the VMware ESXI host?

A.

It will be transmitted in vlan 1.

B.

It will be dropped

C.

It will be transmitted in vlan 2

D.

It will be transmitted in vlan 50.

A customer needs to consolidate software, hardware, and backup in a single integrated solution to reduce the cost and complexity of their IT environment

Which solution meets the customer needs?

A.

HPE StoreEasy

B.

HPE StoreOnce

C.

HPE Apollo Server

D.

HPE SimpliVity

Which feature in a block storage array is effective in decreasing the size of blocks?

A.

thin provisioning

B.

thick provisioning

C.

compression

D.

deduplication

A customer needs a video archive repository initially starting at 30TB internal storage. The repository is expected to grow at 20% annually and should have a lifespan of 3 years.

Which HPE ProLiant server solution meets the customer’s requirements?

A.

HPE ProLiant DL560 Gen10 with LFF SAS drives

B.

HPE ProLiant DL380 Gen10 with LFF SAS drives

C.

HPE ProLiant ML110 with SFF SAS drives

D.

HPE ProLiant DL560 Gen9 with SFF SAS drives

A customer is moving a server from a co-location facility back into their existing data center to comply with new internal policies on data management

Due to budget constraints, the customer cannot purchase any additional switches and will need to use an existing end-of-row design with HPE FlexFabric switches While the server will be installed six racks away from the switches, the total cable run with cable management Is expected to be 35 m.

Which component should be selected when designing the 10 Gbps connectivity option for the server?

A.

QSFP28 Active Optical Cable

B.

SFP+ 10G LC SR Transceiver

C.

SFP+ Active Optical Cable

D.

SFP+ Direct Attach Copper Cable

E.

QSFP+ Active Optical Cable

A customer is subject to regulatory requirements and their data is highly sensitive.

Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?

A.

Secure Encryption

B.

SmartCache

C.

Smart Battery backed-up write-cache

D.

Rapid Parity Initialization

Refer to the exhibit.

Drag the correct protocols from the left to the appropriate area on the topology on the right.