Summer Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: ecus65

HP HPE6-A75 - Aruba Certified Edge Professional Exam

HP HPE6-A75 Premium Access     Download Demo    
Page: 2 / 2
Total 60 questions

Refer to the exhibit.

A.

mike

B.

We can't know this from the screenshot above.

C.

Employee

D.

john

An administrator needs to authenticate users connected to an ArubaOS Switch where the switch authenticates the user, assigns the firewall policies to the user, and processes some of the users' traffic. Which connection method should the administrator configure on the ArubaOS-Switch?

A.

Per-user tunneled node

B.

Split-tunneled mode

C.

Per-port tunneled node

D.

VLAN tunneled mode

Which is a valid policy simulation types in ClearPass? (Select three.)

A network administrator can set the OSPF metric-type on an AOS-Switch to Type 1 or Type 2. What is the difference?

A.

A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.

B.

A Type 2 metric assigns cost 1 to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.

C.

A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.

D.

A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.

Which protocol do Mobility Controllers (MCs) use to detect a failed Mobility Master (MM)?

A.

VRRP

B.

SNMP

C.

PAPI

D.

IPSec

Which ArubaOS CLl command can an administrator execute to determine if AP load balancing is enabled in a cluster?

A.

show switches

B.

show lc-cluster group-membership

C.

show aaa cluster essid

D.

show ap active

Refer to the exhibit.

Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator seesthe output shown in the exhibiton Switch-1.

What is a typical issue that could cause this output?

A.

a hardware issue, such as a broken cable

B.

asymmetric routing introduced by a routing configuration error

C.

an issue with queuing, caused by mismatched QoS settings

D.

mismatched IP addresses on the VLAN for the link

Refer to the exhibit.

A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?

A.

The standby uses its own port in the link aggregation to forward the fabric.

B.

The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.

C.

The standby uses the typical load sharing algorithm, and it might select either its port or the commander’s port.

D.

The standby selects the port on the designated forwarder for the aggregation.