Summer Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: ecus65

Nutanix NCM-MCI-5.20 - Nutanix Certified Master - Multicloud Infrastructure (NCM-MCI) 5.20

Page: 1 / 5
Total 167 questions

Refer to the exhibit.

An administrator receive the warning massages shown in the exhibit while validating cluster conversion from EXSi to AHV.

What should the administrator do to address this warning in v Center Server?

A.

Keep active adapters od different speeds as active standby

B.

Remove adapters that are active but not homogeneous.

C.

Keep homogeneous adapter as active and standby

D.

Remove the standby adapters under Teaming and Failover.

A customer has NearSync configured. When the administrator tries to restore a snapshot from 3 minutes ago, it is not available. The snapshots are happening at 15-minute intervals instead of at the 5-minute configured interval. When the protection domain was initially set up, the snapshots were happening at the expected 5-minute interval.

What should the customer do to enable the snapshots to happen at the expected interval?

A.

Utilize Metro Availability to meet this requirement

B.

Change the protection domain to use Async DR

C.

Fix a connectivity issue because the protection domain reverted to Async

D.

Configure the protection domain to take snapshots on 15-minute intervals

An organization is running a Nutanix Cluster based on AOS 5.10.x and VMware vSphere 6.7. Currently, the CVM network is segmented and Storage only nodes not present.

A new security project based on NSX is coming. VMware Distributed Virtual Switches are required. The administrator needs to prepare the environment for the new project.

Which step should the administrator use to initiate the project?

A.

Enable Nutanix Flow at the Prism Central Level

B.

Manually disable CVM network Segmentation

C.

Convert storage only nodes into vSphere nodes

D.

Enable Jumbo Frames to accommodate network frames

An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output:

What is causing this issue?

A.

Incorrect link speeds on the switch

B.

The interface is incorrectly configured with Jumbo Frames

C.

A misconfigured bond

D.

A physical layer network problem

An administrator responsible for a VDI environment needs to investigate reports of slow logins. The administrator finds that increasing the number of vCPUs from 2 to 4 will reduce the login times. Production workloads are consuming 75% of the host CPU on the cluster. The administrator increases the vCPU count on all of the VDI VMs.

What are two impacts on the cluster? (Choose two.)

A.

Increase CPU utilization%

B.

Increase CPU ready%

C.

Increase memory utilization%

D.

Increasing CPU counts will decrease memory utilization

An administrator needs to upgrade AOS for an air gapped cluster by using Prism Element.

Which two actions allow the administrator to perform the upgrade? Choose Two

A.

Extract the AOS binaries to the CVM

B.

Manually Upload Binaries to a local http server

C.

Manually Upload AOS binaries and metadata

D.

Use the LCM dark site Option Providing AOS Binaries

An administrator manages the following two Nutanix AOS 5.15 cluster environment:

• Corp-cluster-01

• Corp-cluster-02

The VM images must be available only on Corp-cluster-01, but cannot be checked out to cluster Corp-cluster-02. The images also cannot be checked out to any other clusters that are registered with Prism Central in the future.

Which two configuration settings must the administrator choose when creating the image placement policy that satisfies the stated requirements? (Choose two.)

A.

Create an image placement policy that identifies cluster Corp-cluster-01 as the target cluster

B.

Set the policy enforcement to Soft.

C.

Set the policy enforcement to Hard.

D.

Create an image placement policy that identifies cluster Corp-cluster-02 as the target cluster.

The networking team makes changes to the Top of Rack switches to which the Nutanix cluster are attached. A few VMs are able to communicate with each other on the same node but are unable to connect to other parts of the network.

What is the likely cause of this issue?

A.

There is a VLAN misconfiguration on the VMs.

B.

The vNIC port is disconnected on the affected VMs.

C.

There is a VLAN misconfiguration on the switch.

D.

Jumbo Frame are misconfigured across ports.

An administrator is performing a set of routine checks and notes that Prism Central is running with 4 vCPUs and 21 GB RAM. The organizations environment is based on two Nutanix clusters with 170 VMs plus a Legacy vSphere infrastructure. No manual changes have been done on Prism Central VM.

Which configuration justifies the current Prism Central configuration?

A.

Nutanix Move is running on Prism Central to import VMs from the Legacy Cluster.

B.

Prism Central was installed for Large Deployment environments.

C.

Prism Central is running on the legacy duster and requires more RAM.

D.

Nutanix Leap and Nutanix Flow have been enabled on Prism Central

A company needs to replicate their VMs to a remote site and must have an RPO of less than 1 hour.

When creating a protection domain, what should an administrator do to meet this requirement?

A.

Enable Async Replication with an RPO of 60 minutes

B.

Enable Near-Sync Replication with an RPO of 15 minutes

C.

Enable Entity Sync on the designated VMs

D.

Enable Availability Zones and send the VM to multiple targets