Brocade 150-820 - Brocade Certified Ethernet Fabric Professional 2015

Page: 6 / 6
Total 182 questions

Question # 51

Exhibit:

switch# show ip route

Destination Gateway Port Cost Type Uptime

1 0.0.0.0/0 10.24.64.1 mgmt 1 1/1 S 8m24s

2 1.1.1.0/24 10.1.1.10 Ve 10 1/1 S+ 3m11s

3 1.1.2.0/24 DIRECT Ve 12 0/0 D 3m11s

4 10.24.64.0/20 DIRECT mgmt 1 0/0 D 8m28s

Exhibit:

Referring to the exhibit, which statement is true?

The route to 1.1.1.0/24 is a backup, and only active if the default route goes down.

The 1.1.1.0/24 subnet is in a different VRF.

The default route was dynamically learned.

The 1.1.2.0/24 route was dynamically learned.

You want to form a single link aggregation group between a third-party switch and multiple Brocade VDX switches.

Which two conditions must be met? (Choose two.)

The links must be the same speed.

The nodes must be directly connected to each other.

The nodes must be in the same VCS fabric.

Brocade proprietary LAGs must be configured.

The FCoE initiator is unable to communicate with the FC target as shown in the exhibit.

What are two reasons? (Choose two.)

The IFL between the Brocade VCS Fabric and FC SAN is offline.

The Brocade VDX 6720 that the FCoE initiator is connected to is segmented.

LSAN zoning is not configured correctly.

The FC target is not logged into the SAN.

You must determine where a specific virtual machine defined in a port profile is physically attached to the Brocade VCS Fabric.

Which action would you perform?

Look at the port profile configuration.

Look at the MAC address table.

Look at the VCS Fabric configuration.

Look at the LLDP table.